Load Cell X-130
especially suitable for load measurements
For accurate measurements of compressive forces
The load cell is designed as a low-cost compressive force sensor. In addition, the load cell is suitable for load measurement in lifts, either at the fixed point or under the floor. The measuring signal is proportional to the payload in the cabin when mounted correctly. The solid steel housing and the tight design (IP67) guarantee problem-free operation of the pressure load cell, even under difficult environmental conditions.
The large measuring range of 0.5 – 25 kN and the standardised design allow a wide range of cabin and payload weights to be measured with just a few pressure transducers. The force transducer is compact with a size of 40 x 16 mm.
Properties
- Compact design in solid steel housing
- Low height of only 16 mm
- Central bore
- Optionally available with thrust washer and thrust piece
- Measuring ranges from 0.5 – 25 kN available
Downloads
Installation and deployment
Electrical connection
The force sensors from X-Sensors are based on a strain gauge full bridge with strain gauges. The output signal for this sensor is specified in mV/V. Various input modules of controllers already allow the direct connection of force sensors with strain gauge full bridge. In addition, measuring amplifiers with voltage output (0-10 V) and current output (4-20 mA) are available, which amplify the strain gauge full bridges accordingly. The measuring amplifiers are available in a robust field housing, for DIN rail mounting or in an inline housing.
Mechanical connection / construction
The advantages of the compression force sensors are the easy handling. The force acting from above is measured. The various force sensors are versatile and are used in the areas of material testing machines, in hardness testers, the measurement of compressive forces, press-in force control and as load cells. The mounting of the strain gauge force sensors is uncomplicated, either via the thread or via the prefabricated holes, depending on the model.
Technical specifications
Details
| measuring range | 0…0.5 kN, 0…1 kN, 0…12.5 kN, 0…15 kN, 0…25 kN, 0…4 kN, 0…8 kN |
|---|---|
| Design / force application | |
| direction of force | |
| (K) Measuring range (in kN) | 0.5, 1, 12.5, 15, 25, 4, 8 |
| (K) Electrical connection | M12 – 4pol. plug, open strands, Wago-connector733-105 |
| (K) Cable length | 0.5, 0.6, 2.0, 3.0, 4.0 |
| (K) Mounting position | Measurement under the cabin floor, Measurements on the engine frame |
Contact us!
We are happy to answer your questions about our sensors and find a solution for your application.
X-SENSORS AG
If you have any questions about our products, we are at your disposal.
Mit Erfahrung und Freude an Innovationen
