Yoke Strain Sensor X-103-S13-300
especially suitable for smallest elongations
For accurate measurements on the yoke
The strain transducers from X-Sensors reliably measure even small strains on the surface. Despite the simple screw-on installation, the measured values are comparable to glued-on strain gauges, while avoiding their disadvantages. Thanks to the integrated, extremely low-noise and highly stable signal amplifier, the sensors can be used easily and universally. The solid steel housing and the dense design guarantee problem-free operation, even under difficult environmental conditions.
Properties
- solid steel housing
- easy mounting with metal screws
- TTL frequency output
- Standard connector (DIN)
- very robust construction
Downloads
Measuring principle
How it works
The surface strain sensor X-103 detects the strain between the two screw-on surfaces and amplifies it mechanically. This concentrates the strain on the measuring point, where it can be easily detected with a resistive measuring bridge. The integrated signal amplifier converts the strain gauge signal into a proportional TTL frequency signal. The measurement signal is proportional to the payload in the cabin when mounted correctly.
Technical specifications
Details
| Anwendung | |
|---|---|
| Messbereich | |
| Einbauort | |
| (K) Einbauort | Load measurement at the yoke |
| (K) Kabellänge | 1.5 |
| (K) Elektrischer Anschluss | Wago connector 026-000, Wago connector 231-103 |
| (K) Ausgangssignal | 8-20 kHz |
Contact us!
We are happy to answer your questions about our sensors and find a solution for your application.
X-SENSORS AG
If you have any questions about our products, we are at your disposal.
Mit Erfahrung und Freude an Innovationen
